Get the wideband o2 from holley and. I have a 1972 dodge challenger that has a holley projection 2d fuel injection installed on a 383. I never thought i would end up in this section of the forums, but here goes: I made a manual choke using the correct resistor and a switch.i just . I let the engine idle until it reach its working temp.
I have a 1972 dodge challenger that has a holley projection 2d fuel injection installed on a 383. I never thought i would end up in this section of the forums, but here goes: 345 engine, 5 speed manual trans. Get the wideband o2 from holley and. The carb has been replaced with a holley projection 2d (marine) tbi.in checking the throttle position indicator, the manual states at idle, . Tested the (throttle position sensor) per the manual, was a little off. The ignition system was a mopar electronic . I made a manual choke using the correct resistor and a switch.i just .
345 engine, 5 speed manual trans.
The ignition system was a mopar electronic . I made a manual choke using the correct resistor and a switch.i just . Tested the (throttle position sensor) per the manual, was a little off. The carb has been replaced with a holley projection 2d (marine) tbi.in checking the throttle position indicator, the manual states at idle, . Get the wideband o2 from holley and. I let the engine idle until it reach its working temp. 345 engine, 5 speed manual trans. I never thought i would end up in this section of the forums, but here goes: I have a 1972 dodge challenger that has a holley projection 2d fuel injection installed on a 383.
The ignition system was a mopar electronic . The carb has been replaced with a holley projection 2d (marine) tbi.in checking the throttle position indicator, the manual states at idle, . I never thought i would end up in this section of the forums, but here goes: 345 engine, 5 speed manual trans. I let the engine idle until it reach its working temp.
The ignition system was a mopar electronic . I let the engine idle until it reach its working temp. Get the wideband o2 from holley and. The carb has been replaced with a holley projection 2d (marine) tbi.in checking the throttle position indicator, the manual states at idle, . I never thought i would end up in this section of the forums, but here goes: I have a 1972 dodge challenger that has a holley projection 2d fuel injection installed on a 383. 345 engine, 5 speed manual trans. Tested the (throttle position sensor) per the manual, was a little off.
I let the engine idle until it reach its working temp.
I never thought i would end up in this section of the forums, but here goes: I have a 1972 dodge challenger that has a holley projection 2d fuel injection installed on a 383. I made a manual choke using the correct resistor and a switch.i just . 345 engine, 5 speed manual trans. Tested the (throttle position sensor) per the manual, was a little off. The carb has been replaced with a holley projection 2d (marine) tbi.in checking the throttle position indicator, the manual states at idle, . The ignition system was a mopar electronic . Get the wideband o2 from holley and. I let the engine idle until it reach its working temp.
The carb has been replaced with a holley projection 2d (marine) tbi.in checking the throttle position indicator, the manual states at idle, . Get the wideband o2 from holley and. Tested the (throttle position sensor) per the manual, was a little off. The ignition system was a mopar electronic . 345 engine, 5 speed manual trans.
Get the wideband o2 from holley and. Tested the (throttle position sensor) per the manual, was a little off. The carb has been replaced with a holley projection 2d (marine) tbi.in checking the throttle position indicator, the manual states at idle, . I never thought i would end up in this section of the forums, but here goes: The ignition system was a mopar electronic . I made a manual choke using the correct resistor and a switch.i just . I let the engine idle until it reach its working temp. I have a 1972 dodge challenger that has a holley projection 2d fuel injection installed on a 383.
Tested the (throttle position sensor) per the manual, was a little off.
I never thought i would end up in this section of the forums, but here goes: I made a manual choke using the correct resistor and a switch.i just . The ignition system was a mopar electronic . Get the wideband o2 from holley and. The carb has been replaced with a holley projection 2d (marine) tbi.in checking the throttle position indicator, the manual states at idle, . Tested the (throttle position sensor) per the manual, was a little off. I have a 1972 dodge challenger that has a holley projection 2d fuel injection installed on a 383. 345 engine, 5 speed manual trans. I let the engine idle until it reach its working temp.
Holley Pro Jection 2D Manual : 2 :. Tested the (throttle position sensor) per the manual, was a little off. 345 engine, 5 speed manual trans. I never thought i would end up in this section of the forums, but here goes: The carb has been replaced with a holley projection 2d (marine) tbi.in checking the throttle position indicator, the manual states at idle, . Get the wideband o2 from holley and.
0 comments:
Posting Komentar